Please follow the next steps

  1. 110bs
    Sandblast the restoration surface using aluminium oxide powder (30-50 μm) and applying a pressure of 0.1-0.4 MPa (1-4 kg/cm², 15-58 psi). Avoid chipping by adjusting the air pressure to the type of material and/or the shape of the restoration. Thereafter, clean the restoration for two minutes in an ultrasonic bath and then dry it using an air flow.
  2. 123bs
    Apply phosphoric acid (e.g. K-ETCHANT GEL) to the enamel and let it act for 10 seconds. Thereafter, rinse and dry.
  3. 112bs
    Apply the cement to the restoration surface and place the restoration.
  4. 113bsa

    Remove the cement excess using method A or B:
    A. Polymerise 2 to 5 seconds and remove the excess.
    B. Leave the excess untouched for 2 to 4 minutes after placement. Remove the excess by means of an instrument.

  5. 105f
    Polymerise the entire restoration according to table 1 or 2.
  6. 106bs
    Table 1
  7. 107bs
    Table 2

These procedures have been put together with the greatest care. The "standard procedure" shown above is only intended as a brief indication of the actual procedure to follow. This procedure is for general information purposes only and no rights may be derived from it. To find the detailed instructions for the correct use of the product, Kuraray Dental Benelux refers you to Kuraray Co. Ltd's instructions for use.