Please follow the next steps

As necessary, roughen the adherent surface by sandblasting with 30 to 50 µm alumina powder at an air pressure of 0.1-0.4 MPa (1-4 kg/cm²). The air pressure should be properly adjusted to suit the material and/or shape of the restoration, using caution to prevent chipping. After sandblasting clean it by using an ultrasonic unit for 2 minutes, followed by drying it with an air stream.

Apply phosphoric acid (e.g. K-ETCHANT GEL) to the enamel surface. Leave it for 10 seconds before washing and drying. NOTE: Do not apply phosphoric acid to dentine.

Mix one drop each of ED PRIMER II liquid A&B.

Apply the mixture of the primers to the adherent surface and leave it for 30 seconds.

Remove any excess primer and dry by blowing mild, oil-free air.

Dispense equal amounts of PANAVIA™ F2.0 paste A and B and mix them for 20 seconds

Apply the mixture of the pastes on the restoration. NOTE: Do not apply the paste on the abutment surface.

Place the restoration and remove excess uncured paste with a disposable brush.

Light cure the margins and finish according to the curing timetable. Or...

Self-cure the paste by applying OXYGUARD™ II to the margins. After 3 minutes, remove it with a cotton roll and water spray.

Table curing time PANAVIA™ F2.0