Please follow the next steps

  1. 80PB

    As necessary, roughen the adherent surface by sandblasting with 30 to 50 µm alumina powder at an air pressure of 0.1-0.4 MPa (1-4 kg/cm²). The air pressure should be properly adjusted to suit the material and/or shape of the restoration, using caution to prevent chipping. After sandblasting clean it by using an ultrasonic unit for 2 minutes, followed by drying it with an air stream.

  2. 2P

    Mix one drop each of ED PRIMER II liquid A&B.

  3. 74PB

    Apply the mixture of the primers to the adherent surface and leave it for 30 seconds.

  4. 75PB

    Remove any excess primer and dry by blowing mild, oil-free air.

  5. 5P

    Dispense equal amounts of PANAVIA™ F2.0 paste A and B and mix them for 20 seconds

  6. 86PB

    Apply the mixture of the pastes on the restoration. NOTE: Do not apply the paste on the abutment surface.

  7. 87PB

    Place the restoration and remove excess uncured paste with a disposable brush.

  8. 88PB

    Light cure the margins and finish according to the curing timetable. Or...

  9. 89PB

    Self-cure the paste by applying OXYGUARD™ II to the margins. After 3 minutes, remove it with a cotton roll and water spray.

  10. 10P

    Table curing time PANAVIA™ F2.0

These procedures have been put together with the greatest care. The "standard procedure" shown above is only intended as a brief indication of the actual procedure to follow. This procedure is for general information purposes only and no rights may be derived from it. To find the detailed instructions for the correct use of the product, Kuraray Dental Benelux refers you to Kuraray Co. Ltd's instructions for use.